Add to Compare

Add to wishlist

CROCODILE

GROUT CROCODILE RED 20KG | CROCODILE | 1020

SKU:  107503
0 Reviews
239.00 THB

229.00 THB

  • เป็นผลิตภัณฑ์ผสมสำเร็จสำหรับงานปูกระเบื้องโดยเฉพาะ ผลิตจากปูนซีเมนต์ผสมทรายละเอียดคัดพิเศษและเคมีต่างๆ
  • เนื้อกาวละเอียด ผสมง่าย ฉาบไว เบาแรง
  • กาวซีเมนต์มีระยะการแห้งตัวที่สามารถปรับแต่งแนวร่อง ปรับแต่งระดับกระเบื้องได้ง่าย จึงทำให้มีความสวยงามในการปูมากกว่า
Check Availability for delivery
Check Availability for Store Pick up

Add to Compare

Add to wishlist


GROUT CROCODILE RED 20KG

Cement Tile Adhesive
For swimming pools and large size ceramic tile

  • Professionally formulates for swimming pool tile
  • Great for large size of porcelain tile (60×60 cm or larger), marble, granite and natural stone tile
  • High quality tile adhesive for floors and walls, interior and exterior

INSTALLATION

Preparation
All surfaces on which tile is to be set must be dry, structurally sound, free of all grease, oil, dirt, dust, curing compounds, sealers, coating, efflorescence, old adhesive residues, gypsum based underlayment and any other foreign matter.

Cementitious substrates
Cleaning may be accomplished via mechanical sanding, scraping, or chipping. Surfaces may be cleaned with muriatic acid, if thoroughly flushed and neutralized. It is advised to dampen dry porous concrete before installing ceramic tile with Red Crocodile. Do not leave puddles or standing water on surfaces.

Mixing
Red Crocodile dry powder should be added to clean potable water, at a ratio of 5.4-5.6 L per 20 kg bag. Mix thoroughly until smooth and let mortar slake for 15 minutes before mixing a second time. If a mechanical mixer is used, it must be done at a low speed (≤ 150 rpm). Do not add water, latex, or additional powder after the slaking period. The proper mortar consistency is such that when applied with a notched trowel to the substrate, the ridges formed in the mortar will not flow or slump. Do not use mortar after initial set in bucket. During use, remix the mortar occasionally.

Application
Spread mortar with the flat side of a trowel to key-in substrate, then apply additional mortar to ensure that it cover 100% at the back of the tile. During the setting of tiles, it is advised to occasionally remove a tile to be sure mortar has not skinned over and that sufficient transfer is being made. It is also required that tile be embedded to obtain good transfer of mortar to the tile and for proper alignment. Do not adjust tiles in mortar after they have been set for longer than 10-15 minutes. Please be concern that the bucket life of the mixing has only 3 hours.

Curing and Grouting
A minimum cure is obtained in 48 hours, depending on ambient temperatures. It should be better to use plastic to cover the surface for curing. Normal grouting can be done 48 hours after tile installation is complete.